Apply Glue For Panoramic Roof Frame - AR77.21-P-0800-03LF

Model 205 

with code 413 (Automatic panoramic sliding sunroof) 

Model 222 

with code 398 (Panoramic roof with MAGIC SKY CONTROL) 

Model 222 

with code 413 (Automatic panoramic sliding sunroof) 

Model 253 

with code 413 (Automatic panoramic sliding sunroof) 

Topical note	Notes on removal/installation of bonded elements of panoramic roof		AH77.21-P-0001-01A
	000 588 00 72 00 Sealing and corrosion protection gun		WS97.00-P-0001B

1. Open adhesive cartridges and insert into the sealing and corrosion protection gun.
2. Actuate sealing and corrosion protection gun until the level in the adhesive cartridges is compensated.

   Both adhesive components should exit from openings in adhesive cartridges.

3. Install mixing tube on adhesive cartridges.
4. Actuate sealing and corrosion protection gun until adhesive material amounting to the length of two mixing tubes comes out.

   Press out and discard a quantity of adhesive components amounting to the length of two measuring tubes to ensure uniform mixing.

   Dispose of adhesive properly.

5. Mix one additional measuring tube length for reference.

   The reference adhesive bead serves for checking and confirmation of the adhesive connection before moving for the first time after gluing the panoramic sliding roof frame.

   Dispose of reference adhesive bead properly.

6. Guide sealing and corrosion protection gun with application nozzle along the bonding surfaces on the body flange, thus applying adhesive material uniformly.
7. Immediately remove soiling caused by adhesive.

   Only if necessary.

8. Completely squeeze excess adhesive out of the cartridges after applying and dispose of it properly.