Partially Install Upper Front Longitudinal Member - Ar62.20-P-1287-03LW

Model 205 

Model 213 

Model 238 

Model 253 

Model 293 

The next steps are shown on the left side of the vehicle on model 205 and must be performed in the same way on the right side in the event of damage.

1. Install upper front longitudinal member (1), fit with welding device and fix in place.
2. Drill rivet holes on upper front longitudinal member (1) with Ø 6.7 mm (areas A and B).

   Drill rivet holes from inside through present hole in body (area B).

3. Remove upper front longitudinal member (1) and welding device.
4. Deburr drill holes on upper front longitudinal member (1) and body on both sides.
5. Remove drilling chips.

   Courtesy of MERCEDES-BENZ USA

6. Apply 2-component adhesive to body in cross-hatched areas.

   Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive.

   Courtesy of MERCEDES-BENZ USA

7. Install upper front longitudinal member (1), fit with welding device and fix in place.
8. Rivet upper front longitudinal member (1) with Ø 6.5x12.5 rivets (areas C and D).
9. Upper front longitudinal member (1) (area E).

   Courtesy of MERCEDES-BENZ USA

10. Upper front longitudinal member (1) (area F).

    Inert gas weld in intervals and allow welding area to cool down in between. This reduces heat distortion.

11. Remove welding device.
12. Grind inert gas weld down flat on upper front longitudinal member (1) (area F).

    Grind down flat only in beaded areas and contact surfaces of strut.

    Courtesy of MERCEDES-BENZ USA

    Courtesy of MERCEDES-BENZ USA

13. Install strut (2), fit and fix in place
14. Drill rivet holes on strut (2) with 0 6.7 mm bit (areas G, H, I, J, K, L and M).
15. Remove strut (2).
16. Deburr rivet holes in strut (2) and body on both sides.
17. Remove drilling chips.
18. Coat insides of riveted joints with zinc dust paint.

    Do not coat bonding surfaces with zinc dust paint (areas G, H, J and L).

    Otherwise adhesion problems may occur.

    Observe pretreatment of bonding surfaces.

19. Apply 2-component adhesive to body in cross-hatched areas.

    Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive.

    Courtesy of MERCEDES-BENZ USA

    Courtesy of MERCEDES-BENZ USA

20. Rivet strut (2) with 0 6.5x12.5 rivets (areas N, O, P and Q).
21. Rivet strut (2) with 0 6.4x12 rivets (area R).