Remove/Install Tilting/Sliding Roof Motor - AR77.20-P-3010LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz C300, 2022 Mercedes-Benz C300, 2021 Mercedes-Benz C300, 2020 Mercedes-Benz C300, and 2019 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.0/1
with code 414 (Sliding Sunroof)
Model 213.0/1/2
with code 414 (Sliding Sunroof)
Model 253
with code 414 (Sliding Sunroof)
Model 293
with code 414 (Sliding Sunroof)
Shown on Model 205
Fig 1: Tilting/Sliding Roof Motor Components Location - Model 205.0 With Code 414 (Shown On Model 205)
|
Topical Note |
Information on preventing damage to electronic components due to electrostatic discharge This is the last article for |
AH54.00-P-0001-01A | |
| Remove/Install | |||
| 1 | Perform commissioning of Sliding Sunroof control module (A98/1). | When replacing Sliding Sunroof control module (A98/1). | |
| Model 293 with code 414 (Sliding Sunroof) | AD00.00-P-2000-06FR | ||
| Model 205.0/1 with code 414 (Sliding Sunroof) Model 213.0/1/2 with code 414 (Sliding Sunroof) Model 253 with code 414 (Sliding Sunroof) |
AD00.00-P-2000-04B | ||
| 2 | Move Sliding Sunroof to tilt position. | ||
| 3 | Remove overhead control panel control unit and let hang with connected electric lines. | AR82.20-P-1000LF | |
| 4 | Remove screws (1). | First screw in bolts (1) by hand and then tighten. |
|
| 5 | Remove Sliding Sunroof control module (A98/1). | ||
| 6 | Disconnect electrical connector (2) and remove sliding roof control module (A98/1). | The sliding roof motor (A98/1m1) is a component of the sliding roof control module (A98/1). |
|
| 7 | Install in the reverse order. | ||
| 8 | Normalize Sliding Sunroof. |