Move Soft Top To Repair Position - AR77.30-P-1030LWR

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2023 Mercedes-Benz C43 AMG, 2022 Mercedes-Benz C43 AMG, 2021 Mercedes-Benz C43 AMG, 2020 Mercedes-Benz C43 AMG, and 2019 Mercedes-Benz C43 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.4

Model 238.4

Repair position R1

Courtesy of MERCEDES-BENZ USA

Repair position R2

Courtesy of MERCEDES-BENZ USA

Repair position R3

Courtesy of MERCEDES-BENZ USA

Repair position R4

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Risk of injury when performing check and repair work in area of roll bar	Keep body parts out of the area where the roll bars extend. Do not use the cover in the area of the roll bar as a storage place for objects.	AS91.00-Z-0003-01LCA
	Move soft top to repair position
1	Switch on ignition, actuate brake pedal and unlock soft top system via soft top control switch	When soft top system is completely closed. If the soft top system cannot be unlocked via the soft top control switch. ↓ Unlock soft top system with emergency actuation.	AR77.30-P-0999LWR
2	Move soft top system to repair position R1, R2, R3 or R4	When actuating the soft top (2) manually on the left and right, always lift together with helper. Otherwise the soft top mechanism can be damaged. The hydraulic system must be unpressurized when actuating manually. When the ignition is switched on, the pressure in the hydraulic system is relieved automatically after approx. 7 min. When the ignition is switched on, the pressure in the hydraulic system is relieved automatically after approx. 20 s.
3	Move soft top system to repair position R5	When adjusting the cables for header bows. The hydraulic system must be unpressurized when actuating manually. When the ignition is switched on, the pressure in the hydraulic system is relieved automatically after approx. 7 min. When the ignition is switched on, the pressure in the hydraulic system is relieved automatically after approx. 20 s. The soft top compartment cover must slightly move from position (A) in direction of position (B). Front soft top lock must be locked in position (B).
4	Secure soft top compartment cover (1) at hinge against lowering using an Allen key (4)	On repair position R2, R3 or R4. It is necessary to remove the Allen wrench (4) before adjusting another soft top position.
5	Secure soft top bow (3) against lowering using a suitable aid (5)	On repair position R1, R3 or R5. It is necessary to remove the aid (5) before adjusting another soft top position.
6	Secure soft top bow (3) against lowering with support (7)	On repair position R2. It is necessary to remove the support (7) before adjusting another soft top position. Support	Fig 1
7	Secure soft top (2) against lowering with suitable cord (6)	On repair position R3. It is necessary to remove the cord (6) before adjusting another soft top position.

Fig 1: Identifying Support (230 589 04 63 00)

Courtesy of MERCEDES-BENZ USA