Bottom Rear Center Section Prepare For Installation (Model 167.3) - Ar64.20-P-1000-07MEC
Model 167.3
The higher-level service document as well as the safety information in the service document must be observed.
- Grind mating surfaces on rear-end center section (1) down to bare metal in cross-hatched areas on both sides.
- Remove grinding dust.
- Coat insides of spot weld flanges with zinc dust paint.
The following operation steps 4, 5, 6, 7 are shown on the left side of the vehicle and must be similarly performed on the right side of the vehicle.
- Grind mating surfaces on rear-end center section (1) down to bare metal in cross-hatched areas on both sides.
- Remove grinding dust.
- Coat insides of spot weld flanges with zinc dust paint.
- Punch hole for plug weld in bottom rear-end center section (1) (area A).