Wiring Diagram For DC/DC Converter Control Unit - PE54.10-P-2105-97NCA
Model 167 with code B01 (48V technology) Control unit N83/1
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 64L |
| B95 | Battery sensor | 37L |
| CAN B | Interior CAN | 33K |
| Code 465 | Electric active roll stabilization (EARS) | 12E |
| Code 465 | Electric active roll stabilization (EARS) | 6E |
| Code 490 | Electrohydraulic suspension | 6E |
| Code 490 | Electrohydraulic suspension | 12E |
| F150/2 | Vehicle interior pre-fuse box | 3L |
| F150/2f504 | Electrical fuse 504 | 2K |
| F152/2 | Rear fuse and relay module | 26L |
| F152/2f472 | Fuse 472 | 25L |
| F153/2 | Engine compartment 48V fuse box | 9L |
| F153/2 | Engine compartment 48V fuse box | 15L |
| F153/5 | Trunk 48 V on-board electrical system fuse box | 19L |
| F63 | Pyrofuse | 29L |
| G1/3 | 48 V on-board electrical system battery | 39C |
| N83/1 | DC/DC converter control unit | 4A |
| N83/1 | DC/DC converter control unit | 20A |
| N83/1 | DC/DC converter control unit | 28A |
| N83/1 | DC/DC converter control unit | 38A |
| N83/1 | DC/DC converter control unit | 49A |
| N83/1 | DC/DC converter control unit | 57A |
| N83/1 | DC/DC converter control unit | 12A |
| W106 | Right center longitudinal member ground point | 4E |
| W18/5 | Right B-pillar ground point | 26E |
| X30/33 | Right interior CAN (CAN B) potential distributor electrical connector | 33L |
| Z139z1 | Battery sensor connector sleeve | 36G |