Check Lithium-Ion Battery - AR54.10-P-1215ME
Model 167
With Code B01 (48V technology)
| Risk of fire /risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or orifices. Risk of death due to voltage U >= 25 V AC and U >= 60 V DC. | No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing and glasses. Pour battery acid only into suitable and appropriately marked containers. | AS54.10-Z-0001-01A | |
| Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | AH00.00-Z-0300-01A | |
| Topical note | Notes on battery | AH54.10-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Tests before driving into the workshop in a vehicle with an error in the 48 V on-board electrical system battery (G1/3) or with accident damage | |||
| 1 | Before driving into workshop open the right rear door and perform a visual check of the seat cushion and floor covering in the area of the 48 V on-board electrical system battery (G1/3) for fire or smoke development. | AR47.70-P-0017-01A | |
A2 Fire A3 Heat development If smoke generation or scorched detachable parts can be detected, ↓ immediately make an emergency call using the respective location and country-specific emergency call number, do not touch the 48 V on-board electrical system battery (G1/3) and clear the danger zone. |
|||
| 2 | Before driving into the workshop check whether a pungent odor is detectable in the area of the 48 V on-board electrical system battery (G1/3). | AR47.70-P-0017-01A | |
| Further tests before driving into the workshop in a vehicle with an error in the 48 V on-board electrical system battery (G1/3) or with accident damage | |||
| 3 | If no problems were found in operation steps 1 and 2, the vehicle is to be brought into the workshop. | ||
| 4 | Connect vehicle diagnosis system and run quick test. | ||
| AD00.00-P-2000-06ME | |||
| 5 | Expose 48 V on-board electrical system battery (G1/3). | AR54.10-P-0022ME | |
| 6 | Check housing including threaded connections of 48 V on-board electrical system battery (G1/3) for mechanical deformation, cracks and openings as far as possible. | AR47.70-P-0017-02A | |
| If there is an electrolyte leakage. ↓ Notify MPC/general representative. |
|||
| 7 | Remove 48 V on-board electrical system battery (G1/3). |
If the 48 V on-board electrical system battery (G1/3) has to be replaced due to the former tests or if the 48 V on-board electrical system battery (G1/3) has to be removed for further checks. | |
| AR54.10-P-0022ME | |||
| Take-back of used 48 V on-board electrical system battery (G1/3) | |||
| 8 | Assess transportability of 48 V on-board electrical system battery (G1/3) and enter in analysis sheet. | ||
| Analysis sheet for lithium-ion battery 48 V, form | OF54.10-P-3000-15FR | ||
| Check on-board electrical system battery for 48 volt on-board electrical system, when removed, for transportability | AR54.10-P-0048ME | ||
| Check housing of lithium-ion battery | AR47.70-P-0017-02A | ||
| Check lithium-ion battery for acute damage | AR47.70-P-0017-01A |