Remove/Install Overhead Control Panel Control Unit - AR82.20-P-1000LF
Model 205 (except 205.4)
Model 213
Model 217.3
Model 222
Model 253, 293
Shown on model 222
Shown on model 222
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Perform commissioning of overhead control panel control unit (N70). | When installing new overhead control panel control unit (N70). | |
| Model 293 | AD00.00-P-2000-06FR | ||
| Model 205 (except 205.4), 213, 217.3, 222, 253 | AD00.00-P-2000-04B | ||
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 3 | Insert a plastic card (2) or a similar object (approx. 2 mm thick) along a perpendicular line at the center between roof lining (1) and overhead control panel control unit (N70), unlock the lock (3) in direction of travel (arrow A) and fold overhead control panel control unit down (N70). | ||
| 4 | Release and disconnect all electrical connectors (4) from overhead control panel control unit (N70). | ||
| 5 | Unhook overhead control panel control unit (N70) from brackets (arrows B) and remove. | ||
| 6 | Change bracket for taximeter. | Model 213 with code 336 (Taximeter console in OCP) When installing new overhead control panel control unit (N70). |
|
| 7 | Install in the reverse order. |