Remove/Install Propeller Shaft On Power Takeoff Or Rear Axle Differential - AR41.10-P-0050-18MFA

Model 118, 177, 247 with code M005 (Vehicles with 4MATIC/all-wheel drive)

	Notes on self-locking nuts and bolts	AH00.00-P-0001-01KOA
	Notes on threaded connections fastened using a tightening angle-based tightening process	AH00.00-P-0020-01A

PROPELLER SHAFT

Number	Designation			Model 118, 177, 247
BA41.10-P-1001-01K	Bolt, drive shaft to transmission	Stage 1	Nm	10
		Stage 2	Nm	27
		Stage 3	∠°	90

PROPELLER SHAFT

Number	Designation			Model 118, 177, 247
BA41.10-P-1002-01K	Bolt, flexible coupling to rear axle differential	Stage 1	Nm	40
BA41.10-P-1002-01K	Bolt, flexible coupling to rear axle differential	Stage 2	∠°	90

Fig 1: Identifying Counterholder (176 589 00 40 00)

Courtesy of MERCEDES-BENZ USA

Remove

Make color markings to indicate position of propeller shaft (1) relative to output flange (2a) of power take-off or relative to drive flange (2b) of rear axle differential and to flex disk (3).
Unscrew bolts (A₁ to A₆ ) from output flange (2a) and bolts (B) from drive flange (2b).
Use counterholder. Helper required.

Courtesy of MERCEDES-BENZ USA
Release pilot bushings of flexible coupling (3) using a drift (shop-made tool), as shown, from drive flange (2b) of rear axle differential.
If necessary.

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA
Pull propeller shaft (1) off output flange (2a) or drive flange (2b).
Pull the propeller shaft (1) off the drive flange (2b) carefully.

The pilot bushing (10) in the propeller shaft (1) will otherwise be damaged.

Attach the propeller shaft (1) to the drive flange (2b) carefully.

The pilot bushing (10) in the propeller shaft (1) will otherwise be damaged.

Install
Attach propeller shaft (1) to output flange (2a) or drive flange (2b).
Align the color markings with each other. Vibrations will otherwise occur.
Tighten screws/bolts (B) at drive flange (2b)
Replace the bolts (B).

Use counterholder.

Helper required.

Courtesy of MERCEDES-BENZ USA
Loosely screw in bolts (A₁ to A₆ ) at output flange (2a).
Replace the bolts (A₁ to A₆ ).
Turn color marking (arrow) upward.
Tighten screw/bolt (A₁ ) to specified torque (1st stage)
Tighten screw/bolt (A₂ ) to specified torque (2nd stage)
Use counterholder.

Helper required.
Tighten screws/bolts (A₃ , A₄ , A₁ , A₅ , A₆ ) in stated sequence to specified torque (2nd stage)
Use counterholder. Helper required.
Tighten screw/bolt (A2) to specified tightening angle (3rd stage)
Use counterholder. Helper required.
Tighten screws/bolts (A₃ , A₄ , A₁ , A₅ , A₆ ) in stated sequence to specified tightening angle (3rd stage)
Use counterholder. Helper required.