Remove/Install FM, AM, CL, DAB And KEYLESS-GO Antenna Amplifier - AR82.62-P-8315MFA
Model 118, 177, 247
Fig 1: FM, AM, CL, DAB And KEYLESS-GO Antenna Amplifier Components Location - Model 247 (Shown On Model 177.0)
Shown on model 177.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS Remove/install | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2.1 | Remove upper liftgate trim. | Model 118.6, 177.0, 247 | |
| AR72.20-P-6631MFA | |||
| 2.2 | Remove right C-pillar trim. | Model 118.3, 177.1/9 | |
| AR68.30-P-4490MFV | |||
| 3 | Remove screw/bolt (1). | ||
| 4 | Unclip FM, AM, CL, DAB and KEYLESS-GO antenna amplifier (A2/18). | Fig 2 | |
| 5 | Release and disconnect electrical connectors from FM, AM, ZV, DAB and KEYLESS-GO antenna amplifier (A2/18). | ||
| 6 | Install in the reverse order. |