Remove/Install Boost Pressure Control Flap Actuator - AR09.50-P-8845MFC

Engine 260 in model 118 up to model year 2022 

Engine 260 in model 177, 247 up to model year 2021 

Fig 1: Boost Pressure Control Flap Actuator Components Location - Engine 260 In Model 247 Up To Model Year 2021 (Shown On Engine With Code M016)

Courtesy of MERCEDES-BENZ USA

Shown on engine with code M016 (Uprated engine) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury.  Skin or eye injuries may result when handling hot or glowing objects.	Wear protective gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove engine air intake duct downstream of air filter.		AR09.10-P-8130MFC
2	Remove upper heat shield from exhaust gas turbocharger.	Engine 260 in model 118 up to model year 2022 except code M016 (Uprated engine) Engine 260 in model 177, 247 up to model year 2021 except code M016 (Uprated engine)	AR09.40-P-6045MFC
3	Release electrical connector (1) and disconnect.
4	Remove mount (2).	The linkage is attached either via a cotter pin or a retaining ring.
5	Remove screw/bolts (3).	Screw, boost pressure control flap actuator to exhaust gas turbocharger	*BA09.40-P-1011-02G
6	Remove boost pressure control flap actuator (M16/7).
7	Install in the reverse order.
8	Read out and delete fault memory.
			AD00.00-P-2000-06MFA