Remove/Install Oil Feed Line For Turbocharger - AR09.40-P-6022MRX
Engine 260 in model 118 as of model year 2023
Engine 260 in model 177, 247 as of model year 2022
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. Do not fill engine oil into beverage containers. |
AS18.00-Z-0001-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Remove/install | |||
| 1 | Remove belt-driven starter alternator. | Engine 260 in model 118 as of model year 2023 with code B01 (48V technology) Engine 260 in model 177, 247 as of model year 2022 with code B01 (48V technology) | AR15.40-P-5060MFA |
| 2 | Remove screw (1). | *BA09.40-P-1003-02G | |
| 3 | Remove electric line (2) from oil feed line (3). | ||
| 4 | Unscrew screws (4) and remove oil feed line (3). | ||
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| *BA09.40-P-1002-02G | |||
| Fig 2 | |||
| Fig 1 | |||
| 5 | Install in the reverse order. | ||
| 6 | Check and correct engine oil level. | ||
| AP18.00-P-1812MFA | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 7 | Carry out engine test run and check engine for proper operation and leak tightness. |
TURBOCHARGER
| Number | Designation | Engine 260 | ||
|---|---|---|---|---|
| BA09.40-P-1002-02G | Bolt, feed line/return line to turbocharger/crankcase | Stage 1 | Nm | 8 |
| Stage 2 | ∠° | 60 | ||
TURBOCHARGER
| Number | Designation | Engine 260 | |
|---|---|---|---|
| BA09.40-P-1003-02G | Bolt, coolant return line to oil line | Nm | 5 |