Remove/Install Low-Temperature Circuit Cooler - AR09.41-P-6936MFC
Engine 260 in model 118, 177, 247 with code M016 (Uprated engine)
| Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the overpressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. |
AS20.00-Z-0001-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Remove/install | |||
| 1 | Remove radiator. | Engine 260 in model 118, 177, 247 with code M016 (Uprated engine) Engine 260 in model 118, 177, 247 with code M016 (Uprated engine) except code 2U1 (Radiator shutter) |
AR20.20-P-3865MFD |
| 2 | Drain off low-temperature circuit coolant. | AR09.41-P-6834MFC | |
| 3 | Remove the coolant hoses (5) from the low-temperature circuit cooler (1) and seal the openings with protective covers and suitable stop plugs. | AR09.41-P-1311-01AL | |
| Fig 3 | |||
| Fig 2 | |||
| 4 | Release the catches (3) and remove the condenser from the low-temperature circuit cooler (1). | ||
| 5 | Swivel the low-temperature circuit cooler (1) back out of the guides (2), lift it up and out and remove it by pulling it forward at the bottom. | ||
| 6 | Remove the mounts (4) by turning them (arrows). | When the low-temperature circuit cooler (1) is replaced. | |
| 7 | Check low-temperature circuit cooler (1) for damage. | If there are problems: ↓ replace low-temperature circuit cooler (1). |
|
| 8 | Install in the reverse order. |