Remove/Install Front Stabilizer Bar Link Rod - AR32.35-P-3328XG
Model 463 as of model year 2019
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | AS00.00-Z-0009-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (at least 2 m). | ||
| 2 | Remove wheel and tire assemblies on front axle. | AR40.10-P-1102XG | |
| 3 | Unscrew nuts (1) at lower transverse control arm (2) on left and right side of vehicle. | *BA32.35-P-1006-01A | |
| 4 | Unscrew nuts (3) at torsion bar (4) on left and right side of vehicle. | *BA32.35-P-1006-01A | |
| 5 | Remove torsion bar linkages (5). | ||
| Check | |||
| 6 | Check torsion bar linkages (5) and replace if there is wear or damage. | ||
| Install | |||
| 7 | Install in reverse order. |
STABILIZER BAR/TORSION BAR
| Number | Designation | Model 460, 461 Model 463 up to model year 2019 | Model 463 as of model year 2019 | |
|---|---|---|---|---|
| BA32.35-P-1006-01A | Nut, torsion bar linkage on front axle to torsion bar/transverse control arm at bottom | Nm | - | 95 |