Remove/Install Right Rear Engine Suspension Lug - AR01.20-P-5012-02XGC
Engine 177 in model 463 as of model year 2019
METRIC SCREWS/BOLTS AND NUTS AS PER MBN 10 105, 10 143
| Number | Designation | 8.8 | 10.9 | |
|---|---|---|---|---|
| BA00.10-P-1002-04A | M6x1 | Nm | 9 | 13 |
CYLINDER HEAD
| Number | Designation | Engine 177 | ||
|---|---|---|---|---|
| BA01.30-P-1003-01N | Bolt, heat shield/rear lifting eye to cylinder head | M6 | Nm | 9 |
- Remove screw/bolt (1)
- Open the heat protection for the vacuum hose (2) on the vacuum pump (6).
- Remove the vacuum hose (2) from the vacuum pump (6), place to one side and seal the openings using suitable
stop plugs.
- Remove bolts (7)
- Unclip electric line (3) from engine lifting lug (4).
- Remove screw/bolt/bolts (5)
- Remove the engine suspension lug (4) in an upward direction.
- Install in the reverse order.