(Remove/Install ABS Measuring Ring - AR42.30-P-0160GH)

Model 461 with rear axle 741.171/52/53

Model 463 (except 463.270/271) with rear axle 748

up to model year 2013

G13668656

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Disassemble drive shaft (2) on front axle	Model 461 (except 461.331) with rear axle 741.171/52/53	AR33.30-P-0700A
		Model 463 (except 463.270/271) with rear axle 748 up to model year 2013 except code LQ0 (G650 Landaulet) except code ZQ0 (G 500 4x4² )
		Model 461.331 with rear axle 741.171/53	AR33.30-P-0700GX
2	Clamp drive shaft (2) into place
3	Grind down ABS measuring ring (1) using straight grinder to 2 mm then separate using chisel (arrow)	Do not damage axle shaft (2). Otherwise, the ABS measuring ring (1) may not be correctly seated.
4	Press on new ABS measuring ring (1)	Heat up ABS measuring ring (1) to approx 80°C then press on using a suitable tool.
5	Install in the reverse order