Remove/Install Handle On Roof - AR68.30-P-4330XG
Model 463
as of model year 2019
Shown on the right side of the vehicle on the grab handle in the rear passenger compartment
Shown on the right side of the vehicle on the grab handle in the rear passenger compartment
Fig 1: Handle On Roof Components Location - Model 463 As Of Model Year 2019 (Shown On The Right Side Of The Vehicle On The Grab Handle In The Rear Passenger Compartment)
| Remove | |||
| 1 | Detach the spreader wedges (1) with a suitable tool from the notches (arrows A) and remove in the direction of the arrow (B). | ||
| 2 | Press the clips (2) together in the direction of the arrows (C). | ||
| 3 | Pull the grab handle (3) out of the roof lining. | ||
| 4 | Detach the electrical connector (4) of the left rear passenger compartment dome lamp (E11/1) and right rear passenger compartment dome lamp (E11/2). | Only on the grab handles (3) in the rear passenger compartment. | |
| 5 | Press the clips (2) together in the direction of the arrows (C) and take out of the body mount (5). | ||
| Check | |||
| 6 | Check the condition of the clips (2). | If the clips (2), especially the retaining tabs (2.1) and the clamping brackets (2.2), are damaged or deformed or if the clamping force is not present, ↓ Install new clips (2). |
|
| Install | |||
| 7 | Clip the clips (2) into the grab handle (3) so that the retaining tabs (2.1) engage in the recesses on the grab handle (3). | ||
| 8 | Press the spreader wedges (1) into the clips (2) until the catch hooks (3.1) engage in the spreader wedges (1). | ||
| 9 | Connect the electrical connector (4) with the left rear passenger compartment dome lamp (E11/1) and with the right rear passenger compartment dome lamp (E11/2). | Only on the grab handles (3) in the rear passenger compartment. | |
| 10 | Clip the grab handle (3) in the body mount (5) so that the clamping brackets (2.2) engage on the body mount (5). | ||
| Check | |||
| 11 | Check the grab handle on the roof. | AR68.30-P-4330-01XG |