Remove/Install Complete Outside Mirror - AR88.70-P-9000XG

Model 463 

as of model year 2019 

Shown on left side of vehicle 

Fig 1: Complete Outside Mirror Components Location - Model 463 As Of Model Year 2019 (Shown On Left Side Of Vehicle)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Lower side window.
2	Remove door lining at front door.		AR72.10-P-1000XG
3	Remove inner trim at window frame of front door.		AR72.10-P-6580XG
4	Disconnect electrical connectors (1, 2, 3, 4, 5).	The number of electrical connectors (1, 2, 3, 4, 5) depends on the vehicle equipment.
5	Remove adhesive films (6).
6	Remove screws (7).	In this connection, hold left outside mirror (M21/1) and/or right outside mirror (M21/2).
7	Remove left outside mirror (M21/1) and/or right outside mirror (M21/2).
8	Install in reverse order.
	Calibrate
9.1	Calibrate 360° camera in left or right outside mirror (1) using vehicle diagnosis system.	Model 463 as of model year 2019 with code PA8 (Parking package) When removing left outside mirror (M21/1) or right outside mirror (M21/2).
			AD00.00-P-2000-04B
9.2	Calibrate all the cameras in the 360° camera system using the vehicle diagnosis system.	Model 463 as of model year 2019 with code PA8 (Parking package) When removing left outside mirror (M21/1) or right outside mirror (M21/2).
			AD00.00-P-2000-04B
	Check
10	Perform function test of left outside mirror (M21/1) and/or right outside mirror (M21/2).