Remove/Install Turn Signal Lamp In Fender - AR82.25-P-4728XG
Model 463
as of model year 2019
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove | |||
| 1 | Unclip seal (1). | Fig 2 | |
| 2 | Starting at the catch hook (arrow A), unclip the left turn signal lamp (E6/1) or right turn signal lamp (E6/2) from the holder (2) in the direction of the arrow (B). | Fig 2 | |
| 3 | Disconnect the electrical connector (3). | ||
| Check | |||
| 4 | Check centerings (C) on holder (2) for damage. | If the centerings (C) on the holder (2) are damaged: ↓ Install new bracket (2). |
|
| 5 | Check centerings (D) on left turn signal lamp (E6/1) or right turn signal lamp (E6/2) for damage. | If the centerings (D) on the left turn signal lamp (E6/1) or right turn signal lamp (E6/2) are damaged: ↓ Replace left turn signal lamp (E6/1) or right turn signal lamp (E6/2). |
|
| 6 | Check catch hooks (E, F, G, H, I) on seal (1) for damage. | If the catch hooks (E, F, G, H, I) on the seal (1) are damaged: ↓ Replace seal (1). |
|
| Install | |||
| 7 | Connect electrical connector (3). | ||
| 8 | Insert rear centering (D) on left turn signal lamp (E6/1) or right turn signal lamp (E6/2) into rear centering (C) of holder (2). | ||
| 9 | Clip left turn signal lamp (E6/1) or right turn signal lamp (E6/2) into holder (2) against the direction of the arrow (B). | ||
| 10 | Position seal (1) onto holder (2). | ||
| 11 | Clip seal (1) into holder (2) in the sequence (E, F, G, H, I). |