Remove/Install Turn Signal Lamp In Fender - AR82.25-P-4728GW

Model 461 

Model 463 

up to model year 2019 

Fig 1: Install Turn Signal Lamp In Fender Components Location - Model 463 Up To Model Year 2019

Courtesy of MERCEDES-BENZ USA

Shown on model 436.342 

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove
1	Switch off ignition
2	Remove screw from turn signal lamp in fender and detach turn signal lamp from the fender until the electrical connector underneath is accessible
3	Disconnect electrical connector from turn signal lamp and remove turn signal lamp
4	Remove sealing compound from the housing of the turn signal lamp (2) and socket (1) using a suitable tool and clean the housing of the turn signal lamp (2) and socket (1)	When replacing the light source or the housing of the turn signal lamp (2) or socket (1). If the sealing compound cannot be removed without causing damage. ↓ Replacing the socket (1) or housing of the turn signal lamp (2).
	Install
5	Apply sealing compound along the join (line A) between the housing of the turn signal lamp (2) and socket (1) and at the transition between the electrical contacts (3) and socket (1) in the area of the sealing surface (4)	The sealing surface (4) should be free of dust, oil, grease, wax, dirt residues and other adhesive components. In order to avoid adhesion and sealing problems. The contact surfaces of the electrical contacts (3) must remain clear. In order to ensure electrical conductivity. Sealant	*BR00.45-Z-1001-01A
6	Connect electrical connector of turn signal lamp, insert turn signal lamp in the recess on the fender and screw tight	The electric lines may not be kinked or stretched. In order to avoid damage to the wiring harness.