Remove/Install Rear Axle Level Sensor - AR82.10-P-0005XG

Model 463 

as of model year 2019 

Fig 1: Rear Axle Level Sensor Components Location - Model 463 As Of Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Raise vehicle.		AR00.60-P-1006A
2	Disconnect electrical connector (1).
3	Unscrew nut (2) and unhook linkage (3) from rear left level sensor (B22/7) or rear right level sensor (B22/10).	Do not twist the rear left level sensor (B22/7) or the rear right level sensor (B22/10). Observe installation position.
4	Unscrew the nuts (4) and remove rear left level sensor (B22/7) or rear right level sensor (B22/10) with holder (5).
5	Remove the bolts (6) from holder (5).	Only when replacing the rear left level sensor (B22/7) and the rear right level sensor (B22/10).
6	Remove rear left level sensor (B22/7) or rear right level sensor (B22/10) from holder (5).	Only when replacing the rear left level sensor (B22/7) and the rear right level sensor (B22/10).
7	Install in reverse order.
	Calibrate
8	Calibrate the rear left level sensor (B22/7) or rear right level sensor (B22/10).
		Only when replacing the rear left level sensor (B22/7) and the rear right level sensor (B22/10).	AD00.00-P-2000-04B
	Check
9	Check headlamp adjustment, correct if necessary.
		Only when replacing the rear left level sensor (B22/7) and the rear right level sensor (B22/10).	AP82.10-P-8260GA