Remove/Install Left Rear Seat Backrest Cover - AR91.18-P-1874XG
Model 463
as of model year 2019
| Remove/install | |||
| 1 | Remove rear seat backrest. | Only 60 % seat backrest. | AR91.12-P-1620XG |
| 2 | Remove seat belt end fitting screw from lower rear seat. | AR91.12-P-1000XG | |
| *BA91.40-P-1001-01C | |||
| 3 | Remove armrest of separated rear seat backrest. | AR91.12-P-1750XG | |
| 4 | Slide trim (6) upwards and remove. | ||
| 5 | Unhook and unclip cover (1) in area of armrest at rear seat backrest frame. | ||
| 6 | Unclip control lever (2) from frame of rear seat backrest. | ||
| 7 | Remove covers (4). | ||
| 8 | Unclip covers (4a). | ||
| 9 | Remove head restraint guides of rear seat backrest. | AR91.16-P-1775XG | |
| 10 | Remove trim of rear seat backrest. | AR91.12-P-1131XG | |
| 11 | Position long wedge between cover (1) and seat belt guide (5a), unclip catch hooks (5b) and remove cover (5) with seat belt guide (5a). | Fig 2 | |
| 12 | Remove cover (5) and seat belt guide (5a) from seat belt. | ||
| 13 | Unclip catch hooks (5c, 5d) and remove cover (5) from seat belt guide (5a). | ||
| 14 | Remove cover (1) with long wedge (01) from the frame of rear seat backrest. | Fig 2 | |
| 15 | Release and disconnect electrical connector (7) at sidebag. | ||
| 16 | Disconnect electrical connector of seat heating. | Model 463 as of model year 2019 with code PA9 (Active Multicontour Seat package) |
|
| 17 | Remove cover (1) and padding from frame of rear seat backrest. | ||
| 18 | Unhook staple wires of cover (1) at padding from retaining clips (3). | ||
| 19 | Remove cover (1). | ||
| 20 | Install in reverse order. |
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 463 up to model year 2019 | Model 463 as of model year 2019 | |
|---|---|---|---|---|
| BA91.40-P-1001-01C | Bolt on belt end fitting | Nm | 35 | 35 |