Remove/Install Lock Cylinder On Glove Compartment Housing - AR68.10-P-1252XG

Model 463 

as of model year 2019 

Fig 1: Lock Cylinder On Glove Compartment Housing Components Location - Model 463 As Of Model Year 2019

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove
1	Insert emergency key (4) into lock cylinder (1) and turn by approx. 45°.
2	Pull lock cylinder (1) out of the housing (5) with the emergency key (4).	Hold housing (5).
	Check
3	Check position of the edge (arrow A) of the eccentric disk (3) in the housing (5).	The position of the edge (arrow A) is approx. 45°. If the position of the edge (arrow A) is not correct, ↓ Adjust eccentric disk (3).
	Adjust
4	Correct position of the eccentric disk (3) at the edges (arrows B).	Do not press to eccentric disk (3) in axial direction. Otherwise the eccentric disk (3) presses out of the housing (5). Turn eccentric disk (3) at edges (arrows B).
	Install
5	Insert lock cylinder (1) into housing (5) in 45° position with the emergency key (4).	Lock cylinder (1) should arrest noticeably.
6	Turn emergency key (4) to vertical position and pull out of lock cylinder (1).