LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> G550 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electrical System, Equipment & Instruments - 463 Chassis (1 Of 2) >> Testing & Repair >> Disconnect/Connect Battery Ground Line >> Disconnect/Connect Battery Ground Line - AR54.10-P-0003XG

Disconnect/Connect Battery Ground Line - AR54.10-P-0003XG

Model 463 

as of Model year 2019 

G13658787Courtesy of MERCEDES-BENZ USA
  Risk of fire  /risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning  caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death  due to voltage U >= 30V AC and U >= 60V DC. No fires, sparks, open flames, or smoking.
Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers.
AS54.10-Z-0001-01A 
  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A 
  Notes on battery   AH54.10-P-0001-01A 
  Disconnect, connect     
1 Switch off all electrical consumers and disconnect charger or vehicle diagnosis system. If electrical consumers are active, a charger or a vehicle diagnosis system is connected.  
REFER TO SELF DIAGNOSTIC SYSTEMS   NOTES Switch off all electrical consumers.
Danger of damaging the consumer when disconnecting/connecting the ground line (3).
AD00.00-P-2000-04B
2 Switch off ignition and store transmitter key outside of transmitter range (at least 2 m). NOTES All electrical consumers must be switched off.
Because damage can occur when disconnecting/connecting ground line (3) with battery sensor (B95).
 
3 Remove load compartment floor (1).   AR68.80-P-5800XG
4 Loosen nut (2). TORQUE SPECIFICATION Nut, battery sensor to negative battery terminal *BA54.10-P-1005-01K 
5 Disconnect ground line (3) with battery sensor (B95) from negative pole of on-board electrical system battery (G1). IMPORTANT Place ground line (3) with battery sensor (B95) without contact to one side.  
6 Connect in reverse order.    
INSPECT Check     
7 Check time display. If the time display is not correct,

set the time.
 
BATTERY

Number Designation Model 463 as of Model year 2019
BA54.10-P-1005-01K Nut, battery sensor to negative battery terminal Nm 6