Remove/Install Steering Column Module - AR54.25-P-2802GW

Model 463 

as of Model year 2013 up to Model year 2019 /Facelift 2012 

Courtesy of MERCEDES-BENZ USA

Fig 1: Steering Column Module Components Location - Model 463 As Of Model Year 2013 Up To Model Year 2019 /Facelift 2012

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove steering wheel	Remove/install steering wheel	AR46.10-P-0100GW
2	Pry off cover (4) from steering column tube module control unit (N80)	Pry off frame of cover (4) from steering column tube module control unit (N80) at catches using long wedge.
		Mounting wedge	Fig 2
3	Remove steering column tube module control unit (N80) from steering column tube	Do not operate red safety catches in steering column tube module control unit (N80). Otherwise irreparable damage will be caused to the fanfare horns and airbag clock spring contact.
		If the steering column tube module control unit (N80) is in the correct installation position, the assembly display (3) is retracted. When installing a new steering column tube module control unit (N80), the transport protection (2) must be broken off after installation.
4	Unclip cable duct with electrical line from frame of cover (4)
5	Disconnect electrical connector at steering column tube module control unit (N80)	Separate/connect electrical connector at steering column switch module	AR54.25-P-2802-02GW
		The locking clip for the electrical connector is destroyed here and it has to be replaced.
6	Install in the reverse order
7	Perform initialization of DTR control unit with STAR DIAGNOSIS
	Connect STAR DIAGNOSIS and read out fault memory	Initialization of the DTR control unit must only be carried out after the steering column tube module control unit (N80) has been replaced.
			AD00.00-P-2000-04A

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA