Install/Remove Emergency Buffer - AR32.00-P-1000LW

Model 205 

With Code 489 (AIRMATIC Dual Control/semi-active air suspension) 

Model 213 

With Code 489 (AIRMATIC Dual Control/semi-active air suspension) 

Model 238 

With Code 489 (AIR BODY CONTROL) 

Model 253 

With Code 489 (AIR BODY CONTROL) 

Shown on model 205.0, on front axle 

Courtesy of MERCEDES-BENZ USA

Shown on model 205.0, on rear axle 

	Risk of death  caused by vehicle slipping or toppling off during lifting	Only lift vehicle at the lift support points specified by the vehicle manufacturer.	AS00.00-Z-0032-01A
	Notes on AIRmatic	Model 205 with code 489 (AIRMATIC Dual Control/semi- active air suspension) Model 213 with code 489 (AIRMATIC Dual Control/semi- active air suspension) Model 253 with code 489 (AIR BODY CONTROL)	AH32.22-P-1000-02LW
	Notes on AIR BODY CONTROL	Model 238 with code 489 (AIR BODY CONTROL)	AH32.22-P-1000-03LWO
	Install/remove
1	Raise vehicle at affected point		AR00.60-P-1002LWG
2	Place emergency buffer (1) on upper transverse control arm (2)	on front axle. Observe the "R" mark (right side of vehicle) and "L" mark (left side of vehicle). Set of emergency buffers	Fig 2
3	Slide protective tube (5) downwards	On rear axle
4	Insert emergency buffer lower part (3) in upward direction up to end stop using guide pin	On rear axle Set of emergency buffers	Fig 2
5	Insert emergency buffer upper part (4) in downward direction up to end stop using guide pin and turn against emergency buffer lower part (3) up to end stop	on rear axle Set of emergency buffers	Fig 2
6	Slide protective tube (5) together with emergency buffer lower part (3) and emergency buffer upper part (4) upward to suspension strut mount (6)	On rear axle
7	Slowly lower vehicle	The vehicle may be maneuvered only. Otherwise damage to the vehicle may occur.	AR00.60-P-1002LWG
8	Remove in the reverse order