Remove/Install Head Unit - AR82.85-P-1101LWE
Model 213, 238
MODIFICATION NOTES
| 25.10.2022 | Swivel control unit holder (8) at rear upward so that the hooks (arrows) become detached. | Operation step 4. |
Shown On Model 213.0 up to model year 2021
Shown On Model 213.0 from model year 2021
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notice | Notes on avoiding damage to optical fibers during repair work | AH82.60-P-0001-05AK | |
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2.1 | Remove cover from center console. | Model 213, 238 with transmission 725 Model 238 with transmission 725 |
AR68.20-P-2350LWO |
| Model 213 with transmission 725 | AR68.20-P-2350LW | ||
| 2.2 | Remove center console. | Model 213, 238 with transmission 716 Model 238 with transmission 716 |
AR68.20-P-2000LWO |
| Model 213 with transmission 716 | AR68.20-P-2000LWA | ||
| 3 | Remove bolts (5). | ||
| 4 | Remove the control unit holder (8) far enough from the device installation slot that the electrical connectors (3, 4) on the back of the head unit (A26/17) are accessible. | Do not crush or kink or subject electric lines to tension. This will result in damage to the electric lines and can impair their function. |
|
| 5 | Release and disconnect electrical connectors (3, 4). | ||
| 6 | Remove screws (7). | ||
| 7 | Remove head unit (A26/17). | ||
| 8 | Install in the reverse order. | ||
| 9 | Perform commissioning of head unit (A26/17). | When replacing head unit (A26/17). | |
| Model 213 | AD00.00-P-2000-04B | ||
| Model 238 | AD00.00-P-2000-06LWO | ||
| 10 | Calibrate augmented reality camera (B84/14). | When replacing head unit (A26/17). | |
| Model 213 as of model year 2021 with code 21U (Video recording function (Dashcam)) Model 213 as of model year 2021 with code U19 (Augmented reality video) |
AD00.00-P-2000-04B | ||
| Model 238 as of model year 2021 with code 21U (Video recording function (Dashcam)) Model 238 as of model year 2021 with code U19 (Augmented reality video) |
AD00.00-P-2000-06LWO | ||
| 000 588 11 21 00 Adjustment device | WS82.00-P-0151B | ||
| 000 588 00 23 00 Adjusting gauge | WS82.00-P-0028B |