Remove/Install Right Rear Seat Backrest Cover - AR91.18-P-1878LWE

Model 213.0 

With Code 287 (Through-loading feature) 

Model 213.2, 238.3 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove pivot bearing (2) of right backrest with right rear backrest inclination switch	The right rear seat backrest inclination switch can remain on the pivot bearing (2).	AR91.29-P-1772LW
2	Remove head restraint guides		AR91.16-P-1775LW
3	Unhook cover (1) from around backrest frame	: Hook in cover (1) starting at the corners. Press on cover (1) again after hooking it in completely.
		Dismantling tool	Fig 1
4	Guide electrical wiring harness of seat heater through the cover (1)	Model 213.0 with code 287 (Through-loading feature) with code 872 (Left and right rear seat heating) Model 213.2, 238.3 with code 872 (Left and right rear seat heating)
5	Remove seat backrest frame	: Put backrest frame onto padding (3) and align.
6	Slip cover (1) over the padding (3)	: Align seams of cover (1) and position in notches of padding (3).
7	Unclip staple wires (4) from brackets (arrows) on padding (3)	Dismantling tool	Fig 2
8	Remove cover (1) from padding (3)	: Align seams of cover (1) and position in notches of padding (3). Cover (1) must be aligned centrally on padding (3).
9	Install in the reverse order

Fig 1: Identifying Dismantling Tool (205 589 02 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Dismantling Tool (205 589 03 63 00)

Courtesy of MERCEDES-BENZ USA