Remove/Install Pressure And Temperature Sensor Downstream Of Exhaust Gas Turbocharger - AR09.41-P-2014MSA
Engine 256.9 In Model 213, 238, 257
With Code M016 (Uprated engine)
Engine 256.9 In Model 290
Fig 1: Pressure And Temperature Sensor Downstream Of Exhaust Gas Turbocharger Components Location - Engine 256.9 In Model 238 With Code M016
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Topical note | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Remove/install | |||
| 1 | Release and disconnect electrical connector (2). | ||
| 2 | Remove screw (1). | *BA09.41-P-1008-01MRT | |
| 3 | Remove the pressure and temperature sensor downstream of the exhaust gas turbocharger (B28/17). | ||
| 4 | Install in the reverse order. | ||
| 5 | Read out and delete fault memory. | ||
| Engine 256.9 in model 257 with code M016 (Uprated Engine) Engine 256.9 in model 290 |
AD00.00-P-2000-06FR | ||
| Engine 256.9 in model 238 with code M016 (Uprated Engine) | AD00.00-P-2000-06LWO | ||
| Engine 256.9 in model 213 with code M016 (Uprated Engine) | AD00.00-P-2000-04B | ||
| Risk of accident from vehicle starting off by (bruises and burns) resulting from working on the Engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 6 | Carry out Engine test run and check Engine for proper leak tightness and leak tightness. |
CHARGE AIR PIPE/CHARGE AIR COOLING
| Number | Designation | Engine 256.9 | |
|---|---|---|---|
| BA09.41-P-1008-01MRT | Screw, charge air pressure transducer | Nm | 6 |