LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> E350 Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Air Intake, Turbocharging - 213 Chassis 2 Of 2 >> Testing & Repair >> Remove/Install Left Circulation Pump For Low-Temperature Circuit >> Remove/Install Left Circulation Pump For Low-Temperature Circuit - AR09.41-P-6930MRH

Remove/Install Left Circulation Pump For Low-Temperature Circuit - AR09.41-P-6930MRH

Engine 264 in model 213, 238, 257 with code B01 (48V technology) 

MODIFICATION NOTES

22.02.2019 Method description revised. Operation steps 1 to 7.  
Fig 1: Left Circulation Pump For Low-Temperature Circuit Components Location - Engine 264 In Model 213 With Code B01
G13744723Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning  from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.
AS20.00-Z-0001-01A
  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Drain coolant from low-temperature circuit.   AR09.41-P-6834MRH 
2 Remove bracket for compressor. Engine 264 in model 213 with code 489 (AIRMATIC) with code B01 (48V technology)
Engine 264 in model 238, 257 with code 489 (AIR BODY CONTROL) with code B01 (48V technology)
Engine 264 in model 213.0 (except 213.088/089), 213.1 with code 489 (AIRMATIC) with code B01 (48V technology)
AR32.22-P-2009LW
Engine 264 in model 213.2 (except 213.288/289) with code 489 (AIRMATIC) with code B01 (48V technology)
Engine 264 in model 238 with code 489 (AIR BODY CONTROL) with code B01 (48V technology)
AR32.22-P-2009LWO
Engine 264 in model 257 with code 489 (AIR BODY CONTROL) with code B01 (48V technology) AR32.22-P-2009FR
3 Release electrical connector (1) and disconnect.    
4 Remove coolant hose (2) from circulation pump 2 of the low-temperature cooling system (M43/7).   AR20.20-P-7441-01RQ
5 Remove coolant hose (3) from circulation pump 2 of the low-temperature cooling system (M43/7).   AR20.20-P-7441-01RQ
6 Loosen screw (4) and remove circulation pump 2 of the low-temperature cooling system (M43/7) from the bracket (5). INSTALLATION IMPORTANT Observe installation position.  
7 Install in the reverse order.