Remove/Install Boost Pressure Control Flap Actuator - AR09.50-P-8845MRH
Engine 264
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove upper engine cover. | Engine 264 in model 222 | AR01.10-P-2405MRJ |
| Engine 264 in model 213, 238, 257 | AR01.10-P-2405MRH | ||
| Engine 264 in model 205, 253 | AR01.10-P-2405MRI | ||
| Engine 264 in model 167 | AR01.10-P-2405MRK | ||
| 2 | Remove heat shield of exhaust gas turbocharger (1). | *BA09.40-P-1013-02C | |
| 3 | Release and disconnect electrical connector (4). | ||
| 4 | Remove clip (2). | ||
| 5 | Remove bolts (5). | ||
| 6 | Unhook actuator lever (3) and remove boost pressure control flap actuator (M16/7). | ||
| 7 | Install in the reverse order. | ||
| 8 | Connect vehicle diagnosis system, read out fault memory, and delete. | ||
| Engine 264 in model 167 | AD00.00-P-2000-06ME | ||
| Engine 264 in model 205, 213, 222, 253 | AD00.00-P-2000-04B | ||
| Engine 264 in model 257 | AD00.00-P-2000-06FR | ||
| Engine 264 in model 238 | AD00.00-P-2000-06LWO | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. the engine while it is being started or when it is running. | AS00.00-Z-0005-01A | |
| 9 | Perform engine test run and check engine for proper operation. |
TURBOCHARGER
| Number | Designation | Engine 264 | |
|---|---|---|---|
| BA09.40-P-1013-02C | Screw/bolt, heat shield to cylinder head | Nm | 9 |