Install Exit And Warning Lamp With Logo Projector On Front Door - AZ82.20-P-0020-04A

Model 156.9, 166.0/8, 176.0, 205.0/2/3/4, 212.0/2, 213.0/2, 222, 246.2, 253.3/9, 292.3 

Fig 1: Identifying New Passenger Car Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA

The following work procedure describes retrofitting on the left side of the vehicle. Retrofitting on the right side of the vehicle is performed in the same way.

1. Attach black, 2-pin contact socket (2.1) of vehicle wiring harness (2) to exit and warning lamp with logo projector (1).
2. Switch on entrance and exit illumination at overhead control panel control unit.

   The heat sink fitted to the exit and warning lamp with logo projector (1) gets very hot

   If the exit and warning lamp with logo projector (1) do not light up,

   ↓

   swap contact cavity assignment of electrical lines at black 2-pin contact socket (2.1) of vehicle wiring harness (2).

   The appropriate tool is available in the

   basic wiring harness repair kit or the

   supplementary passenger car wiring harness repair kit.

3. Switch off entrance and exit illumination at overhead control panel control unit.

   Courtesy of MERCEDES-BENZ USA

4. Install exit and warning lamp with logo projector (1) into cutout of door trim.

   Do not pinch or crush vehicle wiring harness (2).

   Otherwise, the vehicle wiring harness (2) may be damaged and system failures may occur.

   Install exit and warning lamp with logo projector (1) with the white lens facing downward. Ensure that catch hooks (arrows) are seated and engaged correctly in the door trim.

   Courtesy of MERCEDES-BENZ USA