Prepare CROSSMEMBER For Installation - Ar64.20-P-1060-11LWT

Model 213.2 

Courtesy of MERCEDES-BENZ USA

1. Mark separating points on crossmember (7) and cut (areas A).

   Transfer separation points from vehicle.

2. Grind mating surfaces on crossmember (7) down to bare metal.

   Sand down spot weld flanges to bare metal on both sides.

3. Remove grinding dust.
4. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA

5. Grind mating surfaces on support angle (6) down to bare metal in crosshatched areas.

   Sand down spot weld flanges to bare metal on both sides.

6. Remove grinding dust.
7. Coat insides of spot weld flanges with zinc dust paint.