Prepare CROSSMEMBER For Installation - Ar64.20-P-1060-11LWE

Model 213.0/1 

Courtesy of MERCEDES-BENZ USA

1. Grind mating surfaces on crossmember (2) down to bare metal in cross-hatched areas.

   Sand down spot weld flanges to bare metal on both sides.

2. Remove grinding dust.
3. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA

4. Grind mating surfaces on support angle (3) down to bare metal in crosshatched areas.

   Sand down spot weld flanges to bare metal on both sides.

5. Remove grinding dust.
6. Coat insides of spot weld flanges with zinc dust paint.