Remove/Install Trim At C-Pillar - AR68.30-P-4490LWE

Model 213.0 

Shown with removed side paneling 

Fig 1: C-Pillar Trim Component Location - Model 213.0

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove edge guard in area of C-pillar (2)	Ensure that edge guard is seated correctly.
2	Unclip cover (1)	Retaining clip remains in C-pillar paneling (2).
		Clip remover	Fig 2
3	Loosen C-pillar paneling (2) on C-pillar and rear side paneling, slightly tilt toward center of vehicle and remove toward front	Carefully remove C-pillar paneling (2). Otherwise roof paneling can be damaged. Ensure that C-pillar paneling (2) is seated correctly.
4	Remove cover (3) from C-pillar paneling (2)
5	Remove clamp (4)	Ensure that clip (4) is seated correctly.
6	Guide seatbelt through opening in cove (3) and C-pillar paneling (2)
7	Install in the reverse order

Fig 2: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA