LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> E350 Base >> Repair and Diagnosis >> Accessories & Equipment >> Window Motors & Regulators >> Doors - 213 Chassis 1 Of 2 >> Testing & Repair >> Remove/Install Outer Door Handle On Tailgate - AR72.20-P-7320LW

Remove/Install Outer Door Handle On Tailgate - AR72.20-P-7320LW

Model 205.2 

Model 213.2 

Model 253.1/9 

Fig 1: Outer Door Handle On Tailgate Components Location - Model 213.2 (Shown On Model 253.9 With Code 501)
G13747339Courtesy of MERCEDES-BENZ USA

Shown on model 253.9 with Code 501 (360° camera) 

WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on HANDS-FREE ACCESS   AH80.61-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Switch off ignition and store transmitter key outside of transmission range (min. 2 m).    
2 Remove Rear license plate reinforcement.    
3 Remove center liftgate trim.   AR72.20-P-6618LWS 
4 Disconnect electrical connectors (2).    
5 Disconnect electrical connection (3). Model 205.2, 213.2, 253.1/9 with Code 218 (Rear view camera)
Model 205.2, 213.2, 253.1/9 with Code 501 (360° camera)
 
    IMPORTANT The actual number of connectors (3) will depend on the amount of equipment installed.  
6 Disconnect electrical connection (4).    
7 Unscrew nuts (5).    
8 Remove handle (1) with trunk lid/liftgate external operation switch (S88/8) outward.    
9.1 Use suitable tool to push bracket (6) downward. Model 205.2, 253.1/9
with Code 218 (Rear view camera)
Model 205.2, 253.1/9
with Code 501 (360° camera)
When replacing handle (1).
 
    INSTALLATION IMPORTANT : Use suitable tool to carefully push bracket (6) upwards to end stop.  
9.2 Release catch hooks and pull out retaining clip (7). Model 213.2
with Code 218 (Rear view camera)
 
    Model 213.2
with Code 501 (360° camera) When replacing handle (1).
 
10 Pull out reversing camera (B84/3) or camera for Rear 360° camera (B84/10) inwards. Model 205.2, 213.2, 253.1/9
with Code 218 (Rear view camera)
 
    Model 205.2, 213.2, 253.1/9 with Code 501 (360° camera) When replacing handle (1).  
11 Install in the reverse order    
  Adjust     
12 Adjust Rear end 360° camera (B84/10) with vehicle diagnosis system. Model 205.2, 213.2, 253.1/9 with Code 501 (360° camera)  
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-04B