Retrofit Front Illuminated Door Sill Molding With Mercedes-Benz Lettering - AZ82.20-P-0005-10FR

Model 257.3 

Installation is shown on left side of vehicle as an example. Installation on right side of vehicle is performed analogously.

1. In the hatched area of the contact surface on the door sills with cleaner.

   Courtesy of MERCEDES-BENZ USA

2. Pull off carrier foils (8) from front left illuminated door sill molding (E17/47).

   Note guides (9) during installation.

   Courtesy of MERCEDES-BENZ USA

3. Position illuminated door sill molding at front left (E17/47) onto longitudinal member and uniformly press on.

   Observe guides.

4. Connect black 2-pin connector socket (12) of front left illuminated door sill molding (E17/47) to black 2-pin connector (2.9) of front left illuminated door sill molding line connection (2.1).
5. Clip electrical connector into bracket on cable duct.
6. Route electrical line of front left illuminated door sill molding (E17/47) over body flange on longitudinal member, and fix in place with duct tape (11).

Courtesy of MERCEDES-BENZ USA