Notes On Avoiding Damage To Optical Fibers During Repair Work - AH82.60-P-0001-05AK

Model 117, 118, 156, 164, 166, 167, 169.0/3, 171.4, 172.4, 176, 177, 190, 197, 203, 204, 205, 206, 207, 209, 211.0/2/6, 212, 213, 216.3, 217, 218, 221.0/1, 222, 223, 230, 231, 232, 238, 242, 243, 245.2, 246, 247, 251, 253, 257, 290, 292, 297, 454, 463 

Model 219.3 

With Media Oriented System Transport (MOST) 

Model 293 

Model 420, 447, 448, 470, 471, 636, 639, 906 

The following handling notes must be observed for all repair work which requires optical couplings to be disconnected.

Otherwise the transmitted light pulses will be dampened and the quality of data transfer impaired.

• For repair work, the covers of the optical fibers at the device connection or at the connector of the optical wiring harness must not be prematurely detached.
• Disconnected optical couplings must be covered immediately.
• Do not kink the optical fibers, route over sharp edges or in radii smaller than 25 mm.
• Do not expose optical fibers to temperatures higher than 85°C or lower than -40°C.

The covers of the optical fibers at the device connection or at the connector of the optical wiring harness cannot be separately acquired. The covers of the installed replacement parts or a dry rag can be used.