Remove/Install Wind Deflector - AR77.20-P-2500FR
Model 257, 290
with code 414 (Sliding sunroof)
Shown on model 257 on left side of the vehicle
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Open sliding roof. | ||
| 2 | Press wind deflector (1) at the left and right roof edge with long wedge toward the rear and unhook retaining tab (2) on the left and right upward. | Carefully press wind deflector (1) toward rear. Otherwise, the retaining tabs (2) may be damaged. |
|
| Fig 1 | |||
| 3 | Unhook spring (3) at the left and right out of the sliding sunroof frame and remove wind deflector (1). | ||
| 4 | Install in the reverse order. | ||
| 5 | Read out fault memory with vehicle diagnosis system and carry out teach-in run for the automatic reversing function of the sliding roof. | ||
| AD00.00-P-2000-06FR |