Remove/Install Sliding Roof Panel - AR77.20-P-2854FR

Model 257, 290 

with code 414 (Sliding sunroof) 

Courtesy of MERCEDES-BENZ USA

Shown on model 257 on the right side of the vehicle 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Move sliding roof panel (1) to tilt position.
2	Open sliding roof trim (3).
3	Remove boot (2) on left and right.	Extend boot (2) on left and right first, then at bottom and then at top. Boot (2) on left and right can otherwise be damaged by bending. Only install boot (2) on left and right after adjustment.
4	Remove screws (4) on the left and right.	Tighten bolts (4) only after adjustment.
5	Remove sliding roof panel (1).	Helper required.
6	Install in the reverse order.
7	Adjust sliding roof panel (1).		AR77.20-P-1101FR