Prepare Headliner For Installation - AR68.30-P-4305-16FR

Model 257

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1144-02A	Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide	A 008 989 50 85 09

Courtesy of MERCEDES-BENZ USA

Shown on model 257 with code 414 (Sliding sunroof) and with code 811 (Advanced Sound-System)

Remove sun visor bracket (2) from old roof lining (1).
Do not separate the electrical connectors.
Disconnect electrical connectors and remove sun visor mirror lamp (E14/1, E14/2) from old roof lining (1).
Disconnect electrical connectors and remove microphone for hands-free system (B25/20, B25/21) from old roof lining (1).
Model 257
with code 811 (Advanced sound system)

Disconnect electrical connectors and remove rear center mid-range speaker (3D sound) (H4/117, H4/118) from old roof lining (1).
Model 257
with code 811 (Advanced sound system)

Disconnect electrical connectors and remove center mid-range speaker (3D sound) (H4/119, H4/120) from old roof lining (1).
Expose electrical wiring harness (3) on old roof lining (1) and remove.
Fasten electrical wiring harness (3) with adhesive tape.

Observe routing of lines.
Install detachable parts on new headliner (1) in reverse order.
Model 257
with code 460 (Canada version)

Model 257

with code 494 (US version)

Install new dampings on new roof lining (1).

Take over the installation locations and number of dampings from old roof lining (1).