General Notes About Painting The Body Flange In The Glazing Area - Ah98.00-P-9408-06A
Observe notes about preparation of new parts such as the A-pillar, roof or side walls.
Model all (4xWD, CAR, Light transporter, smart)
The following must be noted for new parts such as the A-pillar, the roof or the side walls:
- Apply repair priming in accordance with the manufacturer's instructions.
- Flange masking with adhesive tape (hand roll, 12 mm wide).
- Top coating of the flange to be repaired.
Shown with model 204.0
- Remove masking from flange to prepare for window glazing.
- Application of primer (flash-off time at least 10 min., maximum break time 24 h).
- Apply bonding to component as per the repair instructions, on the demasked and primed bonding flange (as much coverage as possible).