Remove/Install Front Seat Backrest Cover - AR91.18-P-1820LW
Model 205.0/1/2
except code 555 (AMG-Performance Seat)
Model 253
except code 555 (AMG-Performance Seat)
Model 293
Shown with CODE 873 (Seat heater for driver and front passenger)
| Remove | |||
| 1 | Remove seat backrest padding (2) with cover (1). | AR91.10-P-0003LWE | |
| 2 | Release cover (1) at sides of seat backrest padding (2) and turn inside out. | ||
| 3 | Remove wire rings (4) from seat backrest padding (2) using side cutting pliers (8). | Carefully remove residues from wire rings (4). Otherwise, the seat backrest padding (2) or cover (1) may be damaged. |
|
| 4 | Unclip staple wires (12) from seat backrest padding (2). | Fig 1 | |
| 5 | Remove cover (1) from seat backrest padding (2). | ||
| Install | |||
| 6 | Attach cutout for universal holder on cover (1). | Model 205.0/1/2 with code 866 (Pre-installation for Rear Seat Entertainment System) except code 555 (AMG-Performance Seat) Model 253 with code 866 (Pre-installation for Rear Seat Entertainment System) except code 555 (AMG-Performance Seat) Model 293 with code 866 (Pre-installation for Rear Seat Entertainment System) When replacing the cover (1). |
|
| AR91.10-P-8656-02LWE | |||
| 7 | Position cover (1) in center of seat backrest padding (2) and align seams of cover (1) in cutouts of seat backrest padding (2). | ||
| 8 | Clip upper staple wire (12) into seat backrest padding (2). | Fig 1 | |
| 9 | Check alignment of cover (1) based on marks (arrows C) on upper end of cover (1) and seat backrest padding (2). | ||
| 10 | Clip in remaining staple wires (12) on seat backrest padding (2) start from the inside working outwards. | Fig 1 | |
| 11 | Attach staple wires (6) using new wire rings (4 onto staple wires (5). | shown into the |
|
| Fig 2 | |||
| 12 | Slip cover (1) over seat backrest padding (2). | ||
| 13 | Install seat backrest padding (2) with cover (1). | AR91.10-P-0003LWE |