Transfer Plug Housing For USB Port Electrical Wiring Harness - AN82.60-P-0024-01LW

Model 205.0/2/3/4 with code 154 (CHANGE FROM HU-ENTRY FROM MELCO TO PANASONIC/OPTIMI. HW) except code 355 (Preinstallation for retrofitting navigation system)

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
Notice	Notes on retrofitting electrical/optical lines		AH82.00-P-0000-01A

Fig 1: Identifying New Passenger Car Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying MQS Blade (220 589 01 99 60)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Blade Holder With Clamping Pliers (220 589 01 99 50)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA

To remove, use the blade/holder with clamping pliers as well as the MQS blade from the basic wiring harness repair kit or the supplement passenger car wiring harness repair kit.

Remove secondary fuse (22.1) from black plug connector housing (22).
Lift up locking tab (22.2) of black plug connector housing (22).
Pull plug socket (23) out of black plug connector housing (22) in direction of arrow.

Courtesy of MERCEDES-BENZ USA
Remove secondary fuse (20.1) from black plug connector housing (20).
Insert plug socket (23) into contact cavity "1" of black plug connector housing (20).
Model 205 with code 218 (Reversing camera), model 205 with code 501 (360° camera)
Insert plug socket (43) into contact cavity "2" of black plug connector housing (20).

The white plug connector socket housing was removed from the plug socket (43).
Mount secondary fuse (20.1) onto violet plug connector housing (20).

Courtesy of MERCEDES-BENZ USA