(Retrofit Adaptive Highbeam Assist - AN82.10-P-0010LW)

Model 205.### 1# as of 6/1/15 up to 5/31/18with code 238 (Active lane keeping Assist) with code 632 (Headlamps, LED, static, right-side traffic) 

Model 205.### 1# as of 6/1/15 up to 5/31/18 with code 476 (Lane keeping assist) with code 632 (Headlamps, LED, static, right-side traffic) 

Model 205.### 1# as of 6/1/15 up to 5/31/18 with code 513 (Speed Limit Assist) with code 632 (Headlamps, LED, static, right-side traffic) 

Model 205.### 2# as of 6/1/15 up to 5/31/18 with code 238 (Active lane keeping Assist) with code 631 (Static LED headlamps, left-hand traffic) 

Model 205.### 2# as of 6/1/15 up to 5/31/18 with code 476 (Lane keeping assist) with code 631 (Static LED headlamps, left-hand traffic) 

Model 205.### 2# as of 6/1/15 up to 5/31/18 with code 513 (Speed Limit Assist) with code 631 (Static LED headlamps, left-hand traffic) 

	Update Vehicle Documentation (VeDoc)
2	Enter special equipment into the on-line vehicle data card	Code 608 (Adaptive Highbeam Assist)
3	Attach note Adaptive Highbeam Assist retrofitted as per AN82.10-P-0010LW under field organization texts to design group 54 and design group 82
4	Connect diagnostic system and select vehicle using FIN
			AD00.00-P-2000-04B
5	Carry out variant coding using software calibration number (SCN)	Central gateway (CGW)  Signal acquisition and actuation module (SAM)  Multifunction camera (MFK) Instrument cluster (KI) Headlamp (SW)
6	Disconnect diagnostic system
			AD00.00-P-2000-04B
	Check
7	Perform function test	See owner's manual.