Correcting Rear Articulation Angle At Rear Axle Center Assembly - AR41.10-P-0086-05LW
Model 205 (except 205.386/387/486/487), 253 (except 253.388/389/988/989)
| Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| 000 588 10 62 00 Support plate | WS26.00-P-3309B | ||
| 000 588 11 62 00 Major assembly mount | WS01.00-P-0092B |
CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE
| Number | Designation | Model 205 Except AMG | Model 205 AMG | |
|---|---|---|---|---|
| BE41.10-P-1003-01G | Rear inclination angle of rear propeller shaft relative to rear axle differential (∠3) | ∠° | -1, 00...-0, 17 | -0, 90...-0, 50 |
CHECK VALUES FOR PROPELLER SHAFT ARTICULATION ANGLE
| Number | Designation | Model 253 | |
|---|---|---|---|
| BE41.10-P-1003-01G | Rear inclination angle of rear propeller shaft relative to rear axle differential (∠3) | ∠° | -1, 00...-0, 20 |
REAR AXLE CARRIER
| Number | Designation | Model 205 | Model 253 | |||
|---|---|---|---|---|---|---|
| BA35.10-P-1005-01H | Rear axle differential to front adapter | Rear axle differential (steel) | Nm | 65 | 65 | |
| Rear axle differential (aluminum) | Stage 1 | Nm | 40 | 40 | ||
| Stage 2 | ∠° | 45 | 45 | |||
Correct rear inclination angle (∠3)
To correct the articulation angle at the rear axle differential, appropriate spacer washers (arrow) are available as replacement part.
Spacer washers (arrow) are available in a thickness of 1 mm to 4 mm. Here, 1 mm is equivalent to a change inn articulation angle of approx. 0.25° to 0.33°.