Emergency Release Of Charging Cable Plug At Charger Feed Socket - AR54.10-P-5111LWH
Model 205.013/047/053/054/147/213/247/253
Shown on model 205.247
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | AS00.00-Z-0035-01A | |
| General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | AH00.00-Z-0300-01A | ||
| Notes on battery | AH54.10-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Emergency release | |||
| 1 | Remove screw (1) from guide (2). | Model 205.213/247/253 | |
| 2 | Remove right side cover. | Otherwise the cover could be damaged. |
Fig 1 |
| 3 | Pull plug emergency release (4) in direction of arrow and disconnect charging cable connector (5) from charger feed-in socket. | ||
| 4 | Push plug emergency release (4) back into guide. | ||
| 5 | Close charger feed-in socket flap. | ||
| 6 | Close socket flap in bumper. | ||
| 7 | Install side cover. | ||
| 8 | Tighten bolt (1). | Model 205.213/247/253 |