Remove/Install Soft Top Lock Limit Switch - AR77.39-P-3687LWR

Model 205.4 

Model 238.4 

Shown on right side of vehicle on model 205.4 

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove A-pillar paneling		AR68.30-P-4050LW
2	Mark installation position of limit switch with mount (1) on roof frame
3	Unscrew bolts (2)
4	Disconnect electrical connection (3)
5	Remove limit switch with mount (1)
	Install
6	Connect electrical connector (3) and position limit switch with mount (1) on roof frame
7	Tighten screws/bolts (2)	Align limit switch with mount (1) with the markings. Model 205.4 Bolt, soft top lock to roof frame	*BA77.33-P-1003-02B
		Model 238.4 Bolt, soft top lock to roof frame	BA77.33-P-1003-02C
8	Fully close soft top and check whether soft top lock properly runs into limit switch with mount (1) and locks	If complaint present ↓ Detach screws (2) and readjust limit switch with mount (1). Model 205.4 Bolt, soft top lock to roof frame	*BA77.33-P-1003-02B
		Model 238.4 Bolt, soft top lock to roof frame	BA77.33-P-1003-02C
9	Completely open soft top
10	Install A-pillar paneling		AR68.30-P-4050LW