Remove, Install Net On Wind Deflector - AR77.25-P-1004LWR

Model 205.4 

with code 288 (Draft stop for convertible) 

Model 217.4 

Model 238.4 

with code 288 (Draft stop for convertible) 

Shown on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch on ignition	The ignition must remain switched on during the entire repair procedure.
2	Move out wind deflector (1) with soft top closed	The wind deflector (1) is moved to the service position.
3	Unhook tab (3) on both sides
4	Remove adhesive strip from cover (4)	If installed. Installation:  Renew adhesive strips.
5	Unclip cover (4) on left side
6	Unclip lower net weatherstrip (5) on left side (arrow A)
7	Uniformly pull net (2) out together of lower net weatherstrip (5) and upper net weatherstrip (6) to left (arrows B)	Installation:  The lower net weatherstrip (5) is shorter than the upper net weatherstrip (6). The left and right tab (3) must point toward rear.
	Clean
8	Clean guides for lower net weatherstrip (5) and upper net weather strip (6)
9	Install in the reverse order