Modify Side Paneling In Rear For Draft Stop - AN77.25-P-2199-01LWR

Model 205.4 

Modification shown on right side paneling. Modification on left side paneling analogously.

1. Measure center point on present marking (1) on side paneling (2) and mark.
2. Drill through marked center point.

   Use commercially available drill bit Ø 5 mm.

3. Drill hole in side paneling (2) from inside to approx. 35 mm.

   Use commercially available step drill bit.

   Courtesy of MERCEDES-BENZ USA

4. Cut in extending cover (3) of side paneling (2) several times.

   Courtesy of MERCEDES-BENZ USA